CNC Operator

The environment is very positive, clean, well organize. The machines we operate run three fixtures at ones and the most important task our candidates will perform is to set the part properly to avoid any damage to fixture, part or machine. Candidates will not set-up, maintain or program machine we have a dedicated team of people to set-up, maintain and program. Most parts weight about 5 lbs. and occasionally they work with bigger parts that require team work. Ones the candidate sets the part in place and starts the cycle he/she must inspect the parts done on the previews cycle using precision tools specific to the industry, the cycles run from 2 to 30 min depending on the part. Candidates must also use drill press and port press to drill parts to fit on fixture. During down time candidate may be ask to work the drill press.


Requirements:

The shifts available are as follows:4X10 Monday- Thursday, days off Friday, Saturday, and Sunday
1st shift 5:00 AM to 3:30 PM
2nd shift 3:30 PM to 2:00 AM
The Machines:
Brother TC-324
Hurco VMX42
ACROLOC SIR10
15 Drill press
Pay Rate:
$10 to $14 DOE

Location: Cypress, CAType: CONTRACTDuration: 90 - 120 DaysPay Rate: $10.00 - $14.00 Hourly DOEContact:Volt Services Group